[c-nsp] FWSM Question

[Voll, Scott]

To start with..... What version of IOS are you running on the MSFC?

Personally I would suggest upgrading your FWSM to 3.x code.  Much better
and has the look and feel of ASA 7.x code.

Is it that it's just not passing traffic?  If that's the problem you
will need three things:

NAT 
Route
ACL

Scott

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Paul Stewart
Sent: Thursday, March 22, 2007 8:29 AM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] FWSM Question

Hi folks....

I'm trying to get a FWSM module up and running... can't get
communication
between the MSFC and the FWSM working yet.... figure I'm missing
something
simple..

FWSM Version 2.3(2)
nameif vlan99 Outside security0
same-security-traffic permit inter-interface
mtu Outside 1500
ip address Outside xx.xx.248.1 255.255.255.248
interface Outside



firewall multiple-vlan-interfaces
firewall module 8 vlan-group 1
firewall vlan-group 1  66,99

interface Vlan99
 description FWSM
 ip address xx.xx.248.2 255.255.255.248



Am I missing something really simple here? ;)   This will be for
management
and also for an outside interface ... finally it will also be used for
OSPF
communication between FSWM and MSFC...

VLAN66 is up and running for inter-chassis failover (active/standby) and
works fine....

Thanks in advance,

Paul

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/