[c-nsp] voip over multilink issue
Brian Turnbow
b.turnbow at twt.it
Mon May 7 12:19:01 EDT 2007
Hi
You don't realy give us alot to go on .
12.4T implemented some new voip stuff, did you try 12.4 mainline?
The mainline is based upon the 12.3T code so try that first.
Otherwise you need to run some debugs and find out where the problem lies.
Debug isdn q931 to see the isdn signalling
Debug voip ccapi inout to see the h323 packets.
Regards
Brian
-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of gokhan senol
Sent: lunedì 7 maggio 2007 11.06
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] voip over multilink issue
hi
one of my customer has 7206 vxr router.
I installed pa-2fe card into this router and we got crash problem when the traffic goes through this card. and i decided to upgrade the ios
after upgrade the crash problem was fixed. but this time the voip connection with the remote office was lost even the data connection is ok. and i tried another ios same thing happened. we reset the siemens centrals but problem was still going on. But the interesting thinh in the headquarter we can call pstn and bla bla. but only voip with the branch was fail. And i downgrade the ios again the old one. And now voip is ok but again pa-2fe makes crash.
promlem can be because of the remote office and HQ office ios incompatibility? any idea pls?
thanks a lot
currrent ios
disk2:c7200-is-mz.123-11.T5.bin (pa-2fe problem but voip is ok)
tried ioses
c7200-advipservicesk9-mz.124-11.T1.bin no prob with pa-2fe but voip issue
c7200-spservicesk9-mz.124-11.T1.bin no prob with pa-2fe but voip issue
design is
branch siemens pbx-- branch router >>...multilink interface connection <<.....headquarter 7206vxr-- HQsiemens.
o aaa new-model
ip subnet-zero
no ip rcmd domain-lookup
ip rcmd rcp-enable
ip rcmd rsh-enable
!
ip nbar pdlm bittorrent.pdlm
ip nbar pdlm directconnect.pdlm
ip nbar pdlm eDonkey.pdlm
ip nbar pdlm gnutella.pdlm
!
ip cef
!
!
ip accounting-threshold 32768
isdn switch-type primary-qsig
!
!
voice rtp send-recv
!
voice service pots
!
voice service voip
modem passthrough nse codec g711alaw
!
!
!
!
!
controller E1 1/0
des multichannel e1/p1
channel-group 0 timeslots 1-31 speed 64
!
controller E1 1/1
!
controller E1 3/0
description siemens central connection
pri-group timeslots 1-31
!
class-map match-all gnutella
match protocol gnutella
class-map match-all bittorrent
match protocol bittorrent
class-map match-all kazaa2
match protocol kazaa2
class-map match-all fasttrack
match protocol fasttrack
class-map match-all directconnect
match protocol directconnect
class-map match-all edonkey
match protocol edonkey
!
!
policy-map p2p-policy
class bittorrent
drop
class kazaa2
drop
class directconnect
drop
class edonkey
drop
class fasttrack
drop
class gnutella
drop
!
!
translation-rule 1
Rule 0 * 00
!
bridge irb
!
!
!
interface Multilink1
ip address 10.20.30.2 255.255.255.252
ip tcp header-compression iphc-format
no ip mroute-cache
fair-queue 64 256 25
no cdp enable
ppp multilink
ppp multilink fragment delay 200
ppp multilink interleave
ppp multilink group 1
ip rtp header-compression iphc-format
ip rsvp bandwidth 800
ip rtp priority 16384 16383 256
!
interface GigabitEthernet0/1
des fw
no ip address
ip accounting output-packets
ip nbar protocol-discovery
duplex auto
speed auto
media-type rj45
no negotiation auto
bridge-group 1
!
interface GigabitEthernet0/2
ip address 10.20.60.1 255.255.255.0
ip accounting output-packets
service-policy input p2p-policy
duplex auto
speed auto
media-type rj45
no negotiation auto
h323-gateway voip bind srcaddr 10.20.60.1
!
interface GigabitEthernet0/3
des fw
no ip address
ip accounting output-packets
ip nbar protocol-discovery
duplex auto
speed auto
media-type rj45
no negotiation auto
bridge-group 1
!
interface Serial1/0:0
des BRANCH OFFICE
bandwidth 1984
no ip address
encapsulation ppp
no fair-queue
ppp multilink
ppp multilink group 1
!
!
interface Serial3/0:15
no ip address
no logging event link-status
isdn switch-type primary-qsig
isdn incoming-voice voice
no cdp enable
!
!
!
voice-port 3/0:15
input gain -3
output attenuation 6
echo-cancel coverage 32
bearer-cap Speech
!
!
!
dial-peer voice 10 voip
preference 1
destination-pattern 5287...
progress_ind setup enable 3
modem passthrough nse codec g711alaw
session target ipv4:10.100.0.254
codec g711alaw
fax-relay ecm disable
fax rate 9600
fax nsf 000000
fax protocol t38 ls-redundancy 1 hs-redundancy 1 fallback none
no vad
!
dial-peer voice 21 pots
destination-pattern 0.......
direct-inward-dial
port 3/0:15
prefix 0
!
dial-peer voice 22 pots
destination-pattern 00212.......
direct-inward-dial
port 3/0:15
prefix 00212
!
dial-peer voice 23 pots
destination-pattern 00..........
direct-inward-dial
port 3/0:15
prefix 00
!
dial-peer voice 24 pots
destination-pattern 000.T
direct-inward-dial
port 3/0:15
prefix 000
!
dial-peer voice 31 pots
description to BRANCH OFFICE
destination-pattern [1-5]...
direct-inward-dial
port 3/0:15
forward-digits all
!
____________________________________________________________________________________
No need to miss a message. Get email on-the-go
with Yahoo! Mail for Mobile. Get started.
http://mobile.yahoo.com/mail
_______________________________________________
cisco-nsp mailing list cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
More information about the cisco-nsp
mailing list