[c-nsp] Problem getting right result with PBR

[Jeremy Stinson]

Hello,

I'm having an issue getting PBR to work properly when I try to do both 
source and destination routing. I have the following config:

interface FastEthernet1/0.103
 ip policy route-map client-outbound

access-list 13 permit 1.1.1.1 0.0.0.15
access-list 14 permit 2.2.2.2 0.0.0.15

route-map client-outbound permit 10
 match ip address 13
 set ip next-hop 4.4.4.4

This works, when enabled all traffic originating from 1.1.1.1/28 gets routed 
to the correct place. But I want to say that any traffic coming from 
1.1.1.1/28 going to 2.2.2.2/28 goto next-hop 5.5.5.5. If I add a line of:

route-map client-outbound permit 5
 match ip address 14
 set ip next-hop 5.5.5.5

Traffic is not matched and all traffic continues to go out rule #10. I also 
tried:

route-map client-outbound deny 5
 match ip address 14

And this doesn't help either. Any suggestions? This is running on 12.4(5a) 
on a 7206/400.

Thanks in advance for any pointers.

Jeremy