[c-nsp] AToM xconnects between two 7200s...

Wink dwinkworth at wi.rr.com
Wed May 16 07:32:36 EDT 2007


All:

I am thinking about using AToM to replace some older layer2 only devices that are used to map PVCs from one circuit to another.  

Circuits will be terminating on a 7200 (actually several).  I would like to map these circuits with AToM to some other 7200s.  These other 7200s will be the layer3 termination point for the PVCs.

I would like to terminate these on some kind of virtual or logical interface that can have a hierarchical QoS policy applied to it, and be placed into a VRF.

On the layer3 7200 is a central-services type VRF.  I would like to export routes from this VRF into each of the VRFs that the logical/virtual interfaces are assigned to.

I was thinking a BVI interface, but I understand you can only have 64 of those configured at one time on a 7200 even though you can pick a bridge number between 1 and 255.   Is that still true?  Also no interfaces would actually be in the bridge. Can you apply a policy-map to a BVI interface?

A loopback interface can't have a service-policy attached to it.

Any thoughts?


More information about the cisco-nsp mailing list