[c-nsp] 2611XM and VPN card Issue

[Networkers]

I just installed an AIM-VPN-EP card in a 2611XM with 128Megs RAM.

I'm getting this error message.  Does this mean the card is defective?

Oct  4 10:30:09.122 MDT: %HW_VPN-1-LPRXERR: Virtual Private Network (VPN)
Module0/2: Command Error IPSEC cmd=CRYPTO_ISA_SA_DELETE[0x30] Uproc cmd=DB
Zero[50] status=Unknown[0x10F4]

My policy block in the config (was working before I put the card in):

crypto isakmp policy 5
 encr 3des
 hash md5
 authentication pre-share
 group 2

In other words, using this policy statement I have a working VPN, but when I
install the VPN card I get error messages in the log of the router.

Thanks for any ideas,

Chris

--- some of the show ver ---

Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-JK9O3S-M), Version 12.3(22), RELEASE SOFTWARE
(fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Wed 24-Jan-07 16:49 by ccai
Image text-base: 0x80008098, data-base: 0x81FF5390

ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-JK9O3S-M), Version 12.3(22), RELEASE SOFTWARE
(fc2)

uptime is 11 minutes
System returned to ROM by reload at 17:06:01 MST Sun Feb 28 1993
System restarted at 10:20:05 MDT Thu Oct 4 2007
System image file is "flash:c2600-jk9o3s-mz.123-22.bin"
<snip>

cisco 2611XM (MPC860P) processor (revision 0x100) with 118784K/12288K bytes
of memory.
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
2 FastEthernet/IEEE 802.3 interface(s)
2 ATM network interface(s)
1 Virtual Private Network (VPN) Module(s)
32K bytes of non-volatile configuration memory.
49152K bytes of processor board System flash (Read/Write)