[c-nsp] Error loading IOS onto Cisco2821

[Jonathan Charles]

OK.

Stop.

Go to Best Buy.

Buy a 128MB CF card for $20

Put it into another router and format it.

Then copy the IOS to that router.

Put the CF card into this router.

Boot.


Jonathan

On 10/19/07, omar parihuana <omar.parihuana at gmail.com> wrote:
> Hi,
>
> After load IP Base image (aprox 26MB), I formated  the flash, and re-tried
> the load, and fail again!!!
>
>
> Router#sh flash:
> No files on device
>
> 63983616 bytes available (0 bytes used)
>
> Router#
>
> Loading c2800nm-advipservicesk9-mz.124-15.T1.bin from
> 66.86.36.233 (via GigabitEthernet0/0):
> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
> %Error writing
> flash:/c2800nm-advipservicesk9-mz.124-15.T1.bin (No space
> left on device)
> Sincerely, I'm so tired... and I need the load that image into the router...
> and I don't have one manner for that... pls... sugestions...
>
> Rgds.
>
>
>
>
> On 10/19/07, Jonathan Charles <jonvoip at gmail.com> wrote:
> > Well, from rommon, there isn't much you can do...
> >
> > The goal was to format the flash, and then tftp (in IOS, after it
> loaded)...
> >
> > The timeouts could be a network issue... or you are using an older
> > tftp server that doesn't support files larger than 18.4mb.
> >
> >
> >
> > Jonathan
> >
> > On 10/19/07, omar parihuana < omar.parihuana at gmail.com> wrote:
> > > Hi all,
> > >
> > > I erased the flash and rebooted the router after reset I tried load the
> IOS
> > > in rommon mode, unfortunately the load didn't complete, I tried again
> and
> > > failed again, I thought tftp failure because I get TFTP timeout:
> > >
> > >
> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!..!!!!.!!!!.!!!!.!!!.!.!!.!..!.!!.!!.!..!!..................
> > > [TIMED OUT]
> > > TFTP: Operation terminated.
> > >
> > > After that I think that my flash memory is incorrect, how can I know if
> my
> > > flash is working well, or maybe is not working anymore!?
> > >
> > > Thanks for your response...
> > >
> > > PD. At this moment, my router is in rommon mode, and I don't know
> > > troubleshooting my flash...
> > >
> > >
> > >
> > >
> > > On 10/18/07, Jonathan Charles < jonvoip at gmail.com> wrote:
> > > >
> > > > Well, build a tarball of your IOS and CME files and just archive tar
> > > > /extract it to the flash
> > > >
> > > >
> > > >
> > > > Jonathan
> > > >
> > > > On 10/18/07, Adrian Chadd <adrian at creative.net.au> wrote:
> > > > > On Thu, Oct 18, 2007, Jonathan Charles wrote:
> > > > > > Issue a format flash:
> > > > > >
> > > > > > It takes about 2 seconds and wipes it clean...
> > > > > >
> > > > > > Besides, no one uses SDM anyway...
> > > > >
> > > > > "oh crap all of my CME files are gone!"
> > > > >
> > > > > Its generally fine to start with, but then strange crap happens.
> Phones
> > > > > don't ring right, new phones don't get updated firmware, ATAs stop
> > > working,
> > > > > etc. Then you swear. Loudly. :)
> > > > >
> > > > > (And squeeze flash isn't supported everywhere iirc.)
> > > > >
> > > > >
> > > > >
> > > > > Adrian
> > > > >
> > > > >
> > > > _______________________________________________
> > > > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > > > https://puck.nether.net/mailman/listinfo/cisco-nsp
> > > > archive at
> http://puck.nether.net/pipermail/cisco-nsp/
> > > >
> > >
> > >
> > >
> > > --
> > >  Omar E.P.T
> > > -----------------
> > > Certified Networking Professionals make better Connections!
> > >
> > >
> >
>
>
>
> --
>
> Omar E.P.T
> -----------------
> Certified Networking Professionals make better Connections!
>
>