[c-nsp] Cisco 2851 with HWIC-4ESW and CBR configuration.

[ana.m.henriques at sapo.pt]

Hello,

I try to configure CBR for the interface GIgabit and the fa0/1/0  
(HWIC-4ESW interface) and it return an error.

(config-if)#bridge-group 1
FastEthernet0/1/0 does not support bridging

The System image file is "flash:c2800nm-ipvoice-mz.123-14.T7.bin".

and the configuration is:
...
!
bridge crb
!
!
interface GigabitEthernet0/0.10
  bandwidth 8000
  encapsulation dot1Q 10
  no snmp trap link-status
  no cdp enable
  bridge-group 1
!
!
interface FastEthernet0/1/0
  no ip address
  load-interval 30
  speed 100
  full-duplex
  bridge-group 1
!
bridge 1 protocol ieee
!
...
Any idea to solve the problem?

Thanks
Ana