[c-nsp] 7600 SVI and subinterface combination

[David Granzer]

This is called MUX-UNI and works fine, you need SR or SXH.

David


On 4/8/08, Tom Storey <tom at snnap.net> wrote:
> I wouldnt say so, because of this command:
>
>  switchport
>
>  What would have been a layer 3 port has now become a layer 2 port,
>  hence switchport.
>
>  Thats a guess. Someone may correct or confirm my suspicion.
>
>
>  On 08/04/2008, at 10:18 PM, Alex A. Pavlenko wrote:
>
>  > Colleagues,
>  >
>  > is it possible to combine both SVI(for ip routing) and
>  > subinterface(for
>  > EoMPLS) upon common
>  > interface configured as a trunk on 67xx LAN card?
>  > In other words is following configuration ok?
>  >
>  > interface GigabitEthernet1/1
>  > switchport
>  > switchport trunk encapsulation dot1q
>  > switchport mode trunk
>  > switchport trunk allowed vlan 10,20
>  >
>  > interface GigabitEthernet1/1.20
>  > encapsulation dot1Q 20
>  > xconnect 1.2.3.4 1 encapsulation mpls
>  >
>  > interface Vlan 10
>  > ip address 4.3.2.1 255.0.0.0
>  >
>  > Thanks.
>  >
>  > --
>  > Alex.
>  >
>  > _______________________________________________
>  > cisco-nsp mailing list  cisco-nsp at puck.nether.net
>  > https://puck.nether.net/mailman/listinfo/cisco-nsp
>  > archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>  _______________________________________________
>  cisco-nsp mailing list  cisco-nsp at puck.nether.net
>  https://puck.nether.net/mailman/listinfo/cisco-nsp
>  archive at http://puck.nether.net/pipermail/cisco-nsp/
>