[c-nsp] Standby mode switchport status

[Tom Storey]

> As far as I remember, you should insert SFP and then reload switch.
> If you inserted SFP after boot - SFP port will be disabled, because
> onboard 100FX port will be selected as 'active uplink'.

Bingo that was it.

I didnt think to restart it, as I didnt think it would be something as
simple as that, but after re-starting it I now receive messages about the
SFP (unsupported, thank you Cisco) which is a better sign.

Will try some different SFPs and see if I can get some joy.

Thanks all. :-)