[c-nsp] 6500 not exporting layer 2 netflow data

[Andy Ellsworth]

Jeff Fitzwater wrote:
> Looking at your config again, I don't see the command which enables 
> the PFC flows "mls netflow"  just those two words.
Like "ip flow export layer2-switched vlan", that one doesn't show up in 
a "show run".

6500#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
6500(config)#mls netflow
6500(config)#^Z
6500#sh run | inc mls
mls ip multicast flow-stat-timer 9
mls aging long 300
mls aging normal 60
mls flow ip full
no mls flow ipv6
mls nde sender version 5
no mls acl tcam share-global
mls cef error action freeze

(I'm pretty sure I wouldn't be seeing any layer 2 flows in my "show mls 
netflow ip" output if I didn't have netflow enabled globally...)

-Andy