[c-nsp] EM_WAIT_FOR_ANSWER problem

[tony kam]

Dear All,At our place we are using VIC2E&M card for intranetwork voice commn.Now from one location say...A , we are able to dial to different locations.....But from other locations we are not able to dial in to that particular location....As per our obsrvation the call is reaching the router(A)( analysed by giving "sh voice call summ" ) but still it doesnt go beyond it.....we get output as below...A>sh voice call sumPORT         CODEC    VAD VTSP STATE            VPM STATE============ ======== === ==================== ======================3/0/0         g729r8   y  S_SETUP_REQ_PROC      EM_WAIT_FOR_ANSWER3/0/1         -         -  -                     EM_ONHOOKA>Also if the person at location A, lifts the receiver and dials "9" at the same moment I place a call.....we are able to communicate for a abt 15 sec....When Epabx rx digit "9" then it will throw the control towards router...means Epabx understands that the call is made for WAN rather then LAN.-------------Configuration for ref.----------voice-port 3/0/0 operation 4-wire type 5 signal immediate cptone IN timing inter-digit 500 timing dialout-delay 70!voice-port 3/0/1 operation 4-wire type 5 signal immediate cptone IN timing inter-digit 500 timing dialout-delay 70!dial-peer cor custom!!!dial-peer voice 1 pots destination-pattern 316.. port 3/0/0 prefix #!dial-peer voice 2 pots destination-pattern 316.. port 3/0/1 prefix #!#### CREATED NECESSARY DIAL_PEERS ####-----------------------------------------Pls Suggest..Regards,Tony