[c-nsp] IPv6 on C3550, finally? (12.2(44)SE)

[a. rahman isnaini r.sutan]

Check ipv6 unicast-routing on global config

a. rahman isnaini r.sutan



Simon Lockhart wrote:
> Noticed that 12.2(44)SE was recently released for the Cat3550 switch, and
> feature navigator lists a whole load of IPv6 support. Yay!
> 
> However, it doesn't seem to work very well...
> 
> interface Loopback0
>  no ip address
>  ipv6 address 2001:4B10::100/128
>  ipv6 enable
> end
> 
> lab-sw.rbsov#ping 2001:4b10::100
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 2001:4B10::100, timeout is 2 seconds:
> !!!!!
> Success rate is 100 percent (5/5), round-trip min/avg/max = 0/2/4 ms
> 
> However, if I try to do IPv6 over an ethernet port, it's less successful...
> 
> interface Vlan515
>  no ip address
>  ipv6 address 2001:4B10:0:2::2/64
>  ipv6 enable
> end
> 
> lab-sw.rbsov#ping 2001:4b10:0:2::1
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 2001:4B10:0:2::1, timeout is 2 seconds:
> .....
> Success rate is 0 percent (0/5)
> 
> Running "debug ipv6 packet" on both ends of the link shows packets being
> sent by lab-sw, and replies being sent by the upstream switch (a 3560), but
> the 3550 never learns any neighbours, and pings don't work...
> 
> lab-sw.rbsov#show ipv6 nei
> lab-sw.rbsov#
> 
> Have I missed something needed to make this work, or is it just a work in 
> progress, released prematurely?
> 
> Simon