[c-nsp] Cisco 1841 simple bridging

[Jorge Evangelista]

Hi Pablo,

I think you should execute these commands in routed ports of cisco 1841.

router(config)#bridge 1 protocol ieee
router(config)#bridge irb
router(config)#int fa0/0
router(config-if)#bridge-group 1
router(config-if)#exit router(config)#int fa0/1
router(config-if)#bridge-group 1
router(config-if)#exit


Regards,




On Sat, Jun 7, 2008 at 10:40 AM, Pablo Almido <almidoster at gmail.com> wrote:

> Hi folks, I am trying configure simple bridging in a router 1841, because I
> need that it works in mode bridge, I will put I firewall beetween this
> router and ISP router, and I want to use QoS features of cisco router 1841,
> it is possible configure in router cisco1841, how I can reach it?
>
> Router ISP ---------      Router 1841  (bridge) ------------  Firewall
>
> I have execute the following commands, but I get a error.
>
> router(config)#bridge 1 protocol ieee
> router(config)#bridge irb
> router(config)#int fa0/0/0
> router(config-if)#bridge-group 1
> FastEthernet0/0/0 does not support bridging
> router(config-if)#exit
>
>
> thanks in advance.
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>



-- 
"The network is the computer"