[c-nsp] RBE and PPPOE on the same router

[Paul A]

Hi, folks hope someone here can clue me in on what I need to do.

I currently have a cisco 7200 that I setup a while back for RBE DSL and it's
been working great with no issues. We also have a redback terminating
DSL/PPPOE that we want to shutdown. What we are going to do is move the
PPPOE customers from the redback to the same cisco as the RBE DSL customers.

The PPPOE customers will be on different VPI/VCI's so I'm assuming I can
have RBE and PPPOE coexist without issues. The telco needs to know my mac
address for the cisco to add to their bridge table. Looking at my config I
noticed I have a mac-address on the ATM, mac-address 0000.0cca.22dc.

Should this mac-address be the fast0 interface's mac address thats connected
to the gateway? I'm trying to figure out what mac-address they are looking
for.

I would apriciate if someone could point me in the direction for getting
RBE/PPPOE working together on the same router.


interface ATM5/0
 description VZ CIRTUIT ID 95HFGJ6XXXX
 mac-address 0000.0cca.22dc
 no ip address
 no ip redirects
 no ip unreachables
 ip route-cache policy
 ip route-cache flow
 load-interval 30
 no atm oversubscribe
 atm scrambling cell-payload
 atm uni-version 3.1
 atm ilmi-keepalive
 arp arpa
 arp timeout 0
!
interface ATM5/0.100201 point-to-point
 ip unnumbered Loopback1
 ip access-group dsl-inbound in
 no ip redirects
 no ip unreachables
 ip nat inside
 ip virtual-reassembly
 ip route-cache same-interface
 no ip mroute-cache
 ip policy route-map FA20RM
 no snmp trap link-status
 atm route-bridged ip
 pvc 1/201
  encapsulation aal5snap
  service-policy output fbwfq

Thanks,
 
----------------------------------------------------
Paulo Amaral
MegaNet Communications
P: 508 646 0030
-----------------------------------------------------