[c-nsp] EoMPLS VC up on one side, not on the other.

[Mateusz Błaszczyk]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1



2008/11/15 Stephen Fulton :
> Thanks Stoffi, Oli..
>
> The VLAN was SVI-based on the ME6524.  I've switched to VLAN-based, attached
> to the outgoing interface.. The VC is not coming up, so I've included a
> snippet below, in case I've missed anything.

[...]

> ME6524#sh run int gi1/10.655
> Building configuration...
>
> Current configuration : 112 bytes
> !
> interface GigabitEthernet1/10.655
>  encapsulation dot1Q 655
>  xconnect 10.200.1.8 655 encapsulation mpls
> end
>
> ME6524#sh mpls l2transport vc 655 detail
> Local interface: Gi1/10.655 up, line protocol up, Eth VLAN 655 up
>  Destination address: 10.200.1.8, VC ID: 655, VC status: down
>    Output interface: if-?(0), imposed label stack {}

Can you do "show ip route 10.200.1.8"?
Also "sh run int X" to which above route resolves?

Best Regards,

- -mat
- --
pgp-key 0x1C655CAB


-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)

iD8DBQFJHwgh+BuaDRxlXKsRAt/rAKCUuo7AK0TeFq5rorDt58Its2nBAACeNxjj
SeyH0vlXCFzRA06ecHzUM8o=
=Z15+
-----END PGP SIGNATURE-----