[c-nsp] Cisco 7600 vlan issue

[Mark Tech]

Hi
With my GSR, I can split traffic on seperate physical interfaces, reusing the same vlan #, i.e.

interface GigabitEthernet0/0/6.2
 encapsulation dot1Q 2
 ip address 7.7.7.1 255.255.255.252
 no ip directed-broadcast
 no cdp enable
!
interface GigabitEthernet0/0/7.2
 encapsulation dot1Q 2
 ip address 8.8.8.1 255.255.255.252
 no ip directed-broadcast
 no cdp enable

However with a 7600, if I try to do the same I get the following error:



interface GigabitEthernet1/9.2
 encapsulation dot1Q 2
 ip address 3.3.3.1 255.255.255.252
 no cdp enable
!
7600(config)#interface GigabitEthernet1/10.2
7600(config-subif)# encapsulation dot1Q 2
Command rejected: VLAN 10 not available
7600(config-subif)#


Is there anyway around this? I want the 7600 to act like a router, not a switch!

Regards

Mark