[c-nsp] Moving Sup720 from cat6k to 7600

Church, Charles cchurc05 at harris.com
Thu Sep 4 11:53:38 EDT 2008


Is it possible you're trying to boot an IOS version that doesn't support
that chassis?  I'm sure there is a minimum version for a 7604, and I'm
sure it's more recent than the minimum for the 6500 it came out of.

Chuck

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Gregoire Huet
Sent: Thursday, September 04, 2008 11:18 AM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Moving Sup720 from cat6k to 7600


Hello

I would like to boot a Sup720-3BXL in a 7604 chassis, but it won't.

The sup was previously used in a cat6k chassis (as announced by the 
bootstrap),
and even with a CompactFlash formatted on a running 7604/720-3BXL, the
blade
does not boot.

The compact flash is readable and a 'dir' shows the image, but booting 
on it crashes
after a while (there is just the ATA line displayed), and about 30 
seconds after, it's
returning to rommon with a weird message (that i can possibly report 
here if needed).

Is there a known trick to 'convert' the blade from cat6k to 76xx ?

Thanks a lot for any help

Best regards,

Gregoire Huet

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/


More information about the cisco-nsp mailing list