[c-nsp] c4000

[Farhan Ali Khan]

Earlier switches run CATOS

 

There is a difference between set base CLIs [CAT 4K] and normal CLIs
commands [2960]

 

For 2960

 

Vlan 10 

        Name engineering

Interface x/x

      Switchportt access vlan 10

Or for trunk / Access

            Switchport mode access / trunk

 

For CAT 4K

Run borth cmd from enable mode 

Set vlan 10 name engineering

Set vlan 10 x/x   // where x/x is your interface number like fas0/1

Set vlan 10 x/a-b // x is module name and a - b is port range

 

 

 

By default, Fast Ethernet and Gigabit Ethernet ports are in auto mode. If
the port on the other end of the link is in desirable mode or on, a port in
auto mode automatically becomes a trunk port.

 

set trunk x/x desirable dot1q
set trunk x/x dot1q
 
verify it by "show trunk"
 
clear 
 

 

      

 

 

 

 

 

 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of adrian kok
Sent: 23 September, 2008 3:59 AM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] c4000

 

Hi all

 

ls any different to setup vlan between catalyst 4000

and 2960?

 

I need to setup the cisco2800 to have vlan this 4000

switch

 

ls it easy?

 

how setup the trunk port in 4000 switch?

 

Thank you 

 

 

 

Send instant messages to your online friends http://uk.messenger.yahoo.com 

_______________________________________________

cisco-nsp mailing list  cisco-nsp at puck.nether.net

https://puck.nether.net/mailman/listinfo/cisco-nsp

archive at http://puck.nether.net/pipermail/cisco-nsp/