[c-nsp] EEM event-manager and "event none" question.

[Tassos Chatzithomaoglou]

Event none is used if you want to manually run the eem applet, like you tried to do.

In your case (i guess you need to test your applet), you can create a 2nd applet that uses event none and just sets the 
track 10 state to up (action 1.0 track set 10 state up).
That way you can run the 2nd applet manually which in turn should trigger the 1st applet to run automatically.
Just keep an eye on any other consequences this manual track state change might have on your router.

--
Tassos

luismi wrote on 06/04/2009 19:18:
> I have this code...
> 
> event manager applet A-EU-UP
>  event track 10 state up
>  action 1.0 syslog msg "Track 10 Up. Houston we don't have a problem"
>  action 2.0 cli command "enable"
>  action 3.0 cli command "conf t"
>  action 4.0 cli command "<some commands here>"
> 
> I tried to execute...
> # event manager run  A-EU-UP
> Embedded Event Manager policy EU-ACEL-BACKUP-OFF not registered with
> event none Event Detector
> 
> What is the reason for that message?
> Looks like the EEM code is not running.
> As far as I can read at documentation found with google, I need "event
> none" at the beginning of the applet, but, what is the reason for it?
> When "event none" must be used?
> 
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>