[c-nsp] Controllers for a VWIC2-1MFT-T1/E1

[james edwards]

I have a 2811 which I am trying to set up an ATM T-1 on. T-1 card and AIM
are detected:

Cisco 2811 (revision 49.46) with 249856K/12288K bytes of memory.
2 FastEthernet interfaces
1 Gigabit Ethernet interface
1 Channelized (E1 or T1)/PRI port
1 ATM/Voice AIM

The  VWIC2-1MFT-T1/E1 came in a bundle with the AIM module. I get this when
I boot:

! card type command needed for slot/vwic-slot 0/0,

but the controllers command is not there to configure this card:

yourname(config)#con?
config-register  configuration  connect  control-plane

What am I missing ?

-- 
James H. Edwards
Senior Network Systems Administrator
Judicial Information Division
jedwards at nmcourts.gov