[c-nsp] show dsl int atm 0

[Basha]

Hi Guys,

I need some assistance trying to understand the out put of show dsl int atm
0 command. Specifically the 'bit errors' column.

ATM0/0/0
Alcatel 20190 chipset information
                ATU-R (DS)                      ATU-C (US)
Modem Status:    Showtime (DMTDSL_SHOWTIME)
DSL Mode:        ITU G.992.1 (G.DMT) Annex A
ITU STD NUM:     0x01                            0x1
Vendor ID:       'STMI'                          'GSPN'
Vendor Specific: 0x0000                          0x0008
Vendor Country:  0x0F                            0xFF
Capacity Used:   15%                             67%
Noise Margin:    21.0 dB                          8.0 dB
Output Power:    13.5 dBm                         2.0 dBm
Attenuation:     23.0 dB                         11.5 dB
Defect Status:   None                            None

Last Fail Code:  None
Watchdog Counter: 0x2A
Watchdog Resets: 0
Selftest Result: 0x00
Subfunction:     0x00
Interrupts:      3834 (0 spurious)
PHY Access Err:  0
Activations:     1
LED Status:      OFF
LED On Time:     0
LED Off Time:    0
Init FW:         embedded
Operation FW:    embedded
FW Version:      2.542
                 Interleave             Fast    Interleave              Fast
Speed (kbps):             0             1536             0               512
Cells:                    0          3404282             0         659208107
Reed-Solomon EC:          0                0             0                 0
CRC Errors:               0                0             0                 1
Header Errors:            0                0             0                 0
Bit Errors:               0            48896
BER Valid sec:            0          7725096
BER Invalid sec:          0                0
LOM Monitoring : Disabled

Customer is running video and is seeing lots of packet drops

Thanks