[c-nsp] Ethernet VPN circuits

[Rens]

Oki thanks,
Then I just need to make sure that the switch between the router & the
circuit can be changed to minimum 1504 system mtu right?

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Pelle
Sent: jeudi 5 février 2009 14:58
To: c-nsp
Subject: Re: [c-nsp] Ethernet VPN circuits

Hi.

> 2)  Can I pass the double tag through my switch to our 7206 and configure
a
> double dot1q [outer tag].[inner tag] on my subinterface ?

Yes, but of course it depends on the IOS you are running.

>From a 7206VXR/NPE-G2 running SRC2:

lotta(config)#int GigabitEthernet0/2.123123
lotta(config-subif)#encapsulation dot1Q 123 ?
  native        Make this as native vlan
  second-dot1q  Configure this subinterface as a 1Q-in-1Q subinterface
  <cr>

lotta(config-subif)#encapsulation dot1Q 123 second-dot1q 123 ?
  <cr>

-- 
Pelle
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/