[c-nsp] IOS Initial setup function & DHCP
Tony
td_miles at yahoo.com
Thu Jan 8 05:02:36 EST 2009
I don't have any personal experience, this is just reading the doco. This guide references "autoinstall" in section 6 "configure the router":
http://www.cisco.com/en/US/docs/routers/7200/install_and_upgrade/7201_quick_start/11363q.html
This next doc gives more info on the "autoinstall" process:
http://www.cisco.com/en/US/docs/ios/fundamentals/configuration/guide/cf_config_overview_ps6350_TSD_Products_Configuration_Guide_Chapter.html
including the pre-requisite: "A DHCP server is available on the network to provide IP addresses to networking devices that are using AutoInstall over a LAN connection."
Given the above, I'd say it's highly likely that your shiny new 7201 did issue a DHCP request when it was booted up :(
regards,
Tony.
--- On Thu, 8/1/09, Justin Shore <justin at justinshore.com> wrote:
> From: Justin Shore <justin at justinshore.com>
> Subject: [c-nsp] IOS Initial setup function & DHCP
> To: "'Cisco-nsp'" <cisco-nsp at puck.nether.net>
> Date: Thursday, 8 January, 2009, 2:23 PM
> Can any Cisco people tell me if when a router or switch
> (router in this case) is at the initial setup prompt after
> the very first power-on if the router enables DHCP on
> it's interfaces? I believe I had a brand-new 7201
> running a 12.4T attempt a DHCP DISCOVER while it was at the
> initial setup yes/no prompt. All interfaces were up by
> default until I said 'no' to the prompt at which
> time all interfaces were shutdown. Can anyone tell me if an
> IOS device will attempt to use DHCP during the
> 'setup' process?
>
> The reason I ask would take too long for me to explain
> tonight. If I'm right though it kicked a configuration
> problem in just the right spot to set off a major multi-hour
> outage for us.
>
> Thanks
> Justin
More information about the cisco-nsp
mailing list