[c-nsp] Netflow Sampling

[Oddiraju, Kiran @ London SMC]

Guys,

 

I am trying to configure Netflow sampling interval on a c1801 router
(IOS version "c180x-broadband-mz.124-15.T6.bin"). I was able to enable
Netflow globally and configured it on the interface as well. But I can't
setup sampling, it doesn't like the commands. What am I doing wrong?

 

Config

 

interface FastEthernet0

 ip address 10.15.255.50 255.255.255.252

 ip flow ingress

 ip route-cache flow

 speed 100

 full-duplex

!

 

ip flow-export source FastEthernet0

ip flow-export version 5

ip flow-export destination 10.13.246.50 2055

ip flow-export destination 10.15.246.66 2055

 

 

Netflow-Test(config-if)#ip route-cache flow sampled

                                            ^

% Invalid input detected at '^' marker.

 

Netflow-Test(config)#ip flow-sampling-mode packet-interval ?

% Unrecognized command

 

Many thanks,

Kiran


CB Richard Ellis Limited, Registered Office: St Martin's Court, 
10 Paternoster Row, London, EC4M 7HP, registered in England and Wales No. 3536032. 
Regulated by the RICS and an appointed representative of CB Richard Ellis 
Indirect Investment Services Limited which is authorised and regulated by the Financial Services Authority.

This communication is from CB Richard Ellis Limited or one of its 
associated/subsidiary companies. This communication contains information 
which is confidential and may be privileged. If you are not the intended recipient, 
please contact the sender immediately. Any use of its contents is strictly prohibited 
and you must not copy, send or disclose it, or rely on its contents in any way whatsoever. 
Reasonable care has been taken to ensure that this communication 
(and any attachments or hyperlinks contained within it) is free from computer viruses. 
No responsibility is accepted by CB Richard Ellis Limited or its associated/subsidiary 
companies and the recipient should carry out any appropriate virus checks.