[c-nsp] (no subject)

chris at lavin-llc.com chris at lavin-llc.com
Wed Mar 4 13:28:07 EST 2009


On Wed Mar  4 13:21 , "Leslie Meade"  sent:

>I am trying to bridge my 2821 to one ip to give me redundancy.
>I am using this config to bridge the two ints and I see gig0/1 up and the bvi up but I am not able to ping it
>
>The original config  gig0/1 had the ip of 10.1.1.6 and I could ping everything and get to everything
>Ios C2800NM-IPVOICEK9-M
>
>Any ideas ?
>
>
>bridge irb 
>! 
>interface gig0/0.100 
>encapsulation dot1Q 100 
>bridge-group 100 
>! 
>interface gig0/1.100 
>encapsulation dot1Q 100 
>bridge-group 100 
>! 
>interface BVI100 
>ip address 10.1.1.6 255.255.255.0 
>no shutdown 
>! 
>bridge 100 protocol ieee 
>bridge 100 route ip


Do you have a default route configured? If you are pinging from a remote subnet you'll need a default route.

-chris



More information about the cisco-nsp mailing list