[c-nsp] eigrp questions

[Leslie Meade]

I have two 6509's with sup 32 running HRSP and ether channel links
between them.

On Vlan2 I have two routers, one that handles T1 and the other DMVPN.

All devices have eigrp running. Vlan 2 is my routed network to these
devices. The HRSP ip on the 6509 is 10.1.2.1

 

On my both of my routers that are only connected to one 6509, when I do
a sh ip route eigrp 100 I get the following.

 

 D       10.1.32.0/24 [90/3072] via 10.1.2.3, 1w5d, GigabitEthernet0/0

                                     [90/3072] via 10.1.2.2, 1w5d,
GigabitEthernet0/0

D EX    10.1.204.0/24 [170/3072] via 10.1.2.3, 1w5d, GigabitEthernet0/0

                                         [170/3072] via 10.1.2.2, 1w5d,
GigabitEthernet0/0

D EX 192.168.0.0/16 [170/3072] via 10.1.2.3, 1w5d, GigabitEthernet0/0

                                        [170/3072] via 10.1.2.2, 1w5d,
GigabitEthernet0/0 

 

vfs-core-r1#sh ip route 10.1.1.6

Routing entry for 10.1.1.0/24

  Known via "eigrp 100", distance 90, metric 3072, type internal

  Redistributing via eigrp 100

  Last update from 10.1.2.2 on GigabitEthernet0/0, 1w5d ago

  Routing Descriptor Blocks:

  * 10.1.2.3, from 10.1.2.3, 1w5d ago, via GigabitEthernet0/0

      Route metric is 3072, traffic share count is 1

      Total delay is 20 microseconds, minimum bandwidth is 1000000 Kbit

      Reliability 255/255, minimum MTU 1500 bytes

      Loading 1/255, Hops 1

    10.1.2.2, from 10.1.2.2, 1w5d ago, via GigabitEthernet0/0

      Route metric is 3072, traffic share count is 1

      Total delay is 20 microseconds, minimum bandwidth is 1000000 Kbit

      Reliability 255/255, minimum MTU 1500 bytes

      Loading 11/255, Hops 1

 

My question is how do I change the weighting on the eigrp so that
10.1.2.1 is the preferred, then .2 then .3.

The easy answer is to remove the eigrp from the 2nd 6509, but there is a
move to plug them into the other 6509 for redundancy.

 

 

Leslie