[c-nsp] sup redundancy - hot vs warm

[Swati Sharma]

Hi,

 On 6500 i can see below information... once it says hot standby and
anotherside it says warm... any idea !!!!

Peer Processor Information :
----------------------------
              Standby Location = slot 6
        Current Software state = STANDBY HOT
       Uptime in current state = 3 minutes
                 Image Version = Cisco Internetwork Operating System
Software
IOS (tm) s72033_rp Software (s72033_rp-ADVENTERPRISEK9_WAN-M), Version
12.2(18)SXF12a, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by cisco Systems, Inc.
Compiled Thu 10-Jan-08 23:52 by kellythw
                          BOOT =
disk0:s72033-adventerprisek9_wan-mz.122-18.SXF12a.bin,12
                   CONFIG_FILE =
                       BOOTLDR =
        Configuration register = 0x2102


Router#sh mod
Mod Ports Card Type                              Model              Serial
No.
--- ----- -------------------------------------- ------------------
-----------
  1   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP       SAL26K
  5    2  Supervisor Engine 720 (Active)         WS-SUP720-3BXL     SAL112
  6    2  Supervisor Engine 720 (Warm)           WS-SUP720-3BXL     SAL122
Mod MAC addresses                       Hw    Fw


Regards,