[c-nsp] Need Help troubleshooting a 6513

Renelson Panosky panocisco77 at gmail.com
Mon May 18 10:21:17 EDT 2009


Thank you for all the responses and troubleshoot advice but the problem has
been taking care of. Special thanks to Arie and the command to power up the
module is

config t
power enable module 5

Just in case anybody else come accross that problem again thanks Arie

Renelson

On Mon, May 18, 2009 at 10:14 AM, harbor235 <harbor235 at gmail.com> wrote:

> What type of module is it? Some modules are not supported on all versions
> of code.
> More info is needed, IOS version, module type.
>
> Is this a SPA module? and are youo running SRB code? If so this is fixed in
> SRC code.
>
> mike
>
>   On Fri, May 15, 2009 at 2:05 PM, Renelson Panosky <panocisco77 at gmail.com
> > wrote:
>
>>  Hello list
>>
>> I am configuring a 6513, I've created all my VLANs and assigned them to
>> all
>> my ports however when i do sho vlan i see all my ports except the one in
>> slot 5 but when sho run i can see them with the correct vlan, when i do
>> sho
>> mod here is what i get
>>
>> Mod  Online Diag Status
>> ---- -------------------
>>  1  Pass
>>  2  Pass
>>  3  Pass
>>  4  Pass
>>  5  Not Applicable
>>  7  Pass
>>
>> is that mean the module defective? or the slot is bad ?
>>
>> Any help will be appreciated
>>
>> Renelson
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>
>


More information about the cisco-nsp mailing list