[c-nsp] 2801 WIC errors

[Jeff Wojciechowski]

Hi All,

I have a 2801 running 12.4(22)T3 with WIC1-DSU-T1-V2 giving me some WIC related error logging messages:

wait_ft1_wic_mailbox failed

and

%SERVICE_MODULE-4-WICNOTREADY: Unit Serial0/2/0 not ready for next command,  -Traceback= 0x60D0DAE4 0x60458EEC 0x60458F9C 0x6045A20C 0x6045A5F4 0x6045AE8C 0x6044FDD8 0x60456620 0x60454774 0x604556EC 0x60D5E75C 0x60D3B9F8 0x60D3BB48 0x60D5E75C 0x60D84644 0x61B0D864

Best I can tell is that both log entries occur when I do a 'show service-module' which interestingly enough has incomplete information:


Module type is T1/fractional
    Hardware revision is 1.0, Software revision is 20090901,
    Image checksum is 0x44F2D8, Protocol revision is 0.1
Receiver has no alarms.
Framing is ESF, Line Code is B8ZS, Current clock source is line,
Fraction has 24 timeslots (64 Kbits/sec each), Net bandwidth is 1536 Kbits/sec.
Last module self-test (done at startup): results unretrievable
Last clearing of alarm counters 5d02h
    loss of signal        :    0,
    loss of frame         :    0,
    AIS alarm             :    0,
    Remote alarm          :    0,
    Module access errors  :    0,
Total Data (last 96 15 minute intervals):
Failed to read total data
Failed to read current interval data

I've got a ticket open with TAC and service isn't interrupted but am curious the if this the experts on the list think this is a bad WIC or something else?

Thanks in advance,

Jeff