[c-nsp] SUP2 boot problem

[Jared Mauch]

Is that the latest rommon for sup2?

You may also want to make sure your MFSC2 has the latest rommon as well, (assuming you have a MFSC2 in your sup2, which it would appear is the case).

c6msfc2-rm2.srec.122-17r.S5 is that image.

You also want to check the monlib on the ata disk.

	- Jared

On Nov 16, 2009, at 1:20 PM, Jonas wrote:

> Hello,
> 
> Im trying to upgrade an old SUP2.
> I can boot 12.1.27 from bootflash: without problem.
> When I do reload from IOS with 12.2.18 and boot from disk0: it will give the error below and stay i rommon. disk0: is a 64MB flash disk.
> 
> 
> 
> System Bootstrap, Version 7.1(1)
> Copyright (c) 1994-2001 by cisco Systems, Inc.
> c6k_sup2 processor with 262144 Kbytes of main memory
> 
> Autoboot executing command: "boot disk0:s222-adventerprisek9_wan-mz.122-18.SXF6.bin"
> Command error complete on disk0:
> open: read error...requested 0x4 bytes, got 0xffffffff
> trouble reading device magic number
> loadprog: error - on file open
> boot: cannot load "disk0:s222-adventerprisek9_wan-mz.122-18.SXF6.bin"
> Exit at the end of BOOT string
> rommon 1 >
> 
> 
> 
> When I do "reset" from rommon the SUP2 boots OK from the flash disk with 12.2.18. But not with reload inside IOS again. Any idea what can cause this?
> 
> /Jonas
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/