[c-nsp] SUP2 boot problem

Church, Charles cchurc05 at harris.com
Mon Nov 16 13:44:25 EST 2009


I think you'll get that kind of behavior if the flash card was formatted under CatOS.  Get it booted into native IOS 12.2, then format the card under IOS, and re-copy the image to it.  If it's formatted correctly, you should see some monlib info listed mentioning version it was formatted under, etc.

Chuck 


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Jonas
Sent: Monday, November 16, 2009 1:20 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] SUP2 boot problem


Hello,

Im trying to upgrade an old SUP2.
I can boot 12.1.27 from bootflash: without problem.
When I do reload from IOS with 12.2.18 and boot from disk0: it will give 
the error below and stay i rommon. disk0: is a 64MB flash disk.



System Bootstrap, Version 7.1(1)
Copyright (c) 1994-2001 by cisco Systems, Inc.
c6k_sup2 processor with 262144 Kbytes of main memory

Autoboot executing command: "boot 
disk0:s222-adventerprisek9_wan-mz.122-18.SXF6.bin"
Command error complete on disk0:
open: read error...requested 0x4 bytes, got 0xffffffff
trouble reading device magic number
loadprog: error - on file open
boot: cannot load "disk0:s222-adventerprisek9_wan-mz.122-18.SXF6.bin"
Exit at the end of BOOT string
rommon 1 >



When I do "reset" from rommon the SUP2 boots OK from the flash disk with 
12.2.18. But not with reload inside IOS again. Any idea what can cause 
this?

/Jonas
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/


More information about the cisco-nsp mailing list