[c-nsp] SXI(3) code status?
Jeff Fitzwater
jfitz at princeton.edu
Tue Nov 17 14:34:52 EST 2009
The 6324 100 MM is supported but did not come online in SXI 1, 2 , 2A. It did however work in SXI, which we are running now.
The other flavors are not supported.
Jeff
On Nov 17, 2009, at 12:12 PM, Jared Mauch wrote:
> Release 12.2(33)SXH and later releases do not support the following hardware:
>
> These Ethernet Switching Modules:
>
> –WS-X6024-10FL-MT 24-port 10BASE-FL MT-RJ
>
> –WS-X6248A-TEL 48-port 10/100TX RJ-21
>
> –WS-X6248-RJ-45 48-port 10/100TX RJ-45
>
> –WS-X6248-TEL 48-port 10/100TX RJ-21
>
> –WS-X6324-100FX-SM 24-port 100FX Ethernet
>
> –WS-X6224-100FX-MT 24-port 100FX Ethernet Multimode MT-RJ
>
> –WS-X6316-GE-TX 16-port Gigabit Ethernet RJ-45
>
> –WS-X6416-GE-MT 16-Port Gigabit Ethernet MT-RJ
>
> Now, the caveat is that they did not actually remove the hardware support for some of these until SXI1, so while the release notes say one thing, the actual support varies.
>
> You will see something like this in 'show power':
> 4 WS-X6248A-TEL 112.98 2.69 - - on off (not supported)
> 8 WS-X6248-RJ-45 112.98 2.69 - - on off (not supported)
>
> It does appear the WS-X6324-100FX-MM card does power on for SXI3, but I can't recall if that was the case for SXI2/2a/or 1.
>
> - Jared
>
> On Nov 17, 2009, at 12:05 PM, Chris Phillips wrote:
>
>> Jared,
>>
>> After quickly glancing at the release notes, I was unable to find anything about the removal of hardware support for the 63xx series cards. Do you have a URL or can you be more specific?
>>
>> Thanks in advance!
>>
>> Jared Mauch wrote:
>>> SXI3 has a number of bug fixes for our network, including one that would cause the next-hop to be populated as 'drop' in hardware.
>>> I strongly recommend using it over prior versions of SXI.
>>> Due to the removal of hardware support we replaced the older 63xx/62xx series cards.
>>> - Jared
>>> On Nov 17, 2009, at 10:22 AM, Rubens Kuhl wrote:
>>>> SXI2a running fine with MPLS, QoS, SVIs (no BFD on those... :-(),
>>>> OSPF, BGP. PFC3C-only, no WAN cards/modules, no DFC.
>>>>
>>>>
>>>> Rubens
>>>>
>>>>
>>>>
>>>> On Tue, Nov 17, 2009 at 12:51 PM, Jeff Fitzwater <jfitz at princeton.edu> wrote:
>>>>> I have been running the SXI(3) on a test router with 100M MM 6324, which it did not recognize in previous versions, and so far no complaints but then again it's not in a real world yet.
>>>>>
>>>>>
>>>>> Does anyone else have GOOD or BAD new on SXI(3)?
>>>>>
>>>>>
>>>>> Jeff Fitzwater
>>>>> OIT Network Systems
>>>>> Princeton University
>>>>>
>>>>>
>>>>>
>>>>> _______________________________________________
>>>>> cisco-nsp mailing list cisco-nsp at puck.nether.net
>>>>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>>>>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>>>>
>>>> _______________________________________________
>>>> cisco-nsp mailing list cisco-nsp at puck.nether.net
>>>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>>>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>> _______________________________________________
>>> cisco-nsp mailing list cisco-nsp at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
More information about the cisco-nsp
mailing list