[c-nsp] Flow Control

[Mohammad Khalil]

Dear all

i have 5 giga ethernet interfaces connected via port channel to WiMAX ASN gateway
the device is cisco CISCO7606-S with IOS c7600s72033-advipservicesk9-mz.122-33.SRB2.bin

when i issue the command sh run int po20

interface Port-channel20
 switchport
 switchport access vlan 20
 switchport trunk encapsulation dot1q
 switchport mode access
 flowcontrol receive on
 flowcontrol send on
end
 
sh int po20 | inc flow
  input flow-control is off, output flow-control is off

does that mean that the other device dont support flow control ? or i need something else to enable flow control ?
because i suffer from overruns on the port channel ? is that the problem ?

Thanks in advance
 		 	   		  
_________________________________________________________________
Windows Live: Keep your friends up to date with what you do online.
http://www.microsoft.com/middleeast/windows/windowslive/see-it-in-action/social-network-basics.aspx?ocid=PID23461::T:WLMTAGL:ON:WL:en-xm:SI_SB_1:092010