[c-nsp] WS-X6148A-GE-TX not working with SUP2

[Jonas Björklund]

Hello,

I have a WS-X6148A-GE-TX thats inserted in a SUP2 but only get "Unknown" when I do "sh mod".

The IOS is 12.1(27b)E4.

6500-1#sh mod
Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
   1    2  Catalyst 6000 supervisor 2 (Active)    WS-X6K-SUP2-2GE    SAL10019MNG
   2    2  Catalyst 6000 supervisor 2 (Standby)   WS-X6K-SUP2-2GE    SAD054204FA
   4   16  SFM-capable 16 port 10/100/1000mb RJ45 WS-X6516-GE-TX     SAL06447YCJ
   5   16  SFM-capable 16 port 10/100/1000mb RJ45 WS-X6516-GE-TX     SAD060101AF
   6   48  Unknown                                Unknown            Unknown

6500-1#sh power
system power redundancy mode = redundant
system power total =     1153.32 Watts (27.46 Amps @ 42V)
system power used =       574.56 Watts (13.68 Amps @ 42V)
system power available =  578.76 Watts (13.78 Amps @ 42V)


The same WS-X6148A-GE-TX is working in another chassi with SUP720-3bxl.

On the cisco website I can read that the line card should be supported in SUP2 with the IOS thats running.

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Module_Installation/Mod_Install_Guide/02ethern.html#wp1042813

Any ideas?

/Jonas