[c-nsp] 7600-ES20 L2 and L3 Multiplexing
Antonio Soares
amsoares at netcabo.pt
Mon Sep 21 12:28:30 EDT 2009
Hello group,
I have a ES20 interface configured with L2 services via the "service instance" command. Now i would like to add L3 services to the
same physical interface but i noticed a problem with IPv6:
7600#
7600#conf t
Enter configuration commands, one per line. End with CNTL/Z.
7600(config)#!
7600(config)#interface GigabitEthernet3/0/0.200100
7600(config-subif)# encapsulation dot1Q 200 second-dot1q 100
7600(config-subif)# ip address 20.20.20.254 255.255.255.0
7600(config-subif)# ipv6 address 2001:20::2/64
^
% Invalid input detected at '^' marker.
7600(config-subif)#ipv6 ?
% Unrecognized command
7600(config-subif)#
After removing all the service instance entries, the IPv6 command was accepted. Is this a known limitation ? I saw the same problem
with 12.2(33)SRC2 and 122-33.SRD2a.
Thanks.
Regards,
Antonio Soares, CCIE #18473 (R&S)
amsoares at netcabo.pt
More information about the cisco-nsp
mailing list