[c-nsp] cisco 7206 VXR router

[Detter Werner]

Hi Jack,

you can't add eight 100Mbit-Interfaces additionally. The NPE-G1 has 3 build-in
Gbit-Ports, the 7206VXR chassis is able to handle 6 additional Cards.

One 100MBit FE-Card (PA-FE-TX/FX) allocates 200 Bandwith Points, a 2-Port
FE-Card (PA-2FE-TX/FX) allocates 400 BW-Points.

So, you probably have to buy four PA-2FE-TX/FX-Cards (if you cannot use
the build-in Gbit-Ports for your purposes *or* if you can use them buy
5 PA-FE-TX/FX-Cards :-)

Bye,
Werner

jack daniels schrieb:
> Hi ,
> 
> I'm a bit confused on -
> "Also, don't assume that because you can add 8 100Mbit interfaces, that
> you can use them at full speed.."
> 
> Regards
> 
> 
> 
> On Tue, Sep 29, 2009 at 6:03 PM, Howard Jones <howie at thingy.com> wrote:
> 
>> On 29/09/2009 13:03, Antonio Soares wrote:
>>> Here's the document you need:
>>>
>>> Cisco 7200 Bandwidth Points
>>>
>>>
>> http://www.cisco.com/en/US/products/hw/routers/ps341/prod_presentation_list.html
>>> To add 8 FastEthernet Ports, you will need 4 * PA-2FE-TX. The NPE-G1 has
>> 3 built-in GE interfaces.
>> Also, don't assume that because you can add 8 100Mbit interfaces, that
>> you can use them at full speed...
>>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/


-- 
transnet Internet Services GmbH
Werner Detter - Netmaster

Lilienstr. 3-5 81669 München
http://www.trans.net
support at trans.net