[c-nsp] Strange ME3400 PPS Limit
Tassos Chatzithomaoglou
achatz at forthnet.gr
Wed Apr 14 14:39:10 EDT 2010
This message is printed even with a single default route, if you happen
to use the l2 sdm template.
--
Tassos
Everton da Silva Marques wrote on 14/04/2010 20:41:
> On Wed, Apr 14, 2010 at 12:40:46PM -0400, Jeremy Parr wrote:
>
>> On 14 April 2010 11:57, Jeremy Parr<jeremyparr at gmail.com> wrote:
>>
>>> I have an ME3400 running 12.2(46)SE that will not pass (much) more
>>> than 1000pps through its copper gig port. The interface counters hover
>>> around 1000pps tx/rx, while the bps rate fluctuates (presumable due to
>>> the variable packet sizes getting thrown at it). There are no service
>>> policys or rate limits applied to any of the interfaces. Any thoughts?
>>>
>>> ?5 minute input rate 1681000 bits/sec, 879 packets/sec
>>> ?5 minute output rate 7545000 bits/sec, 1012 packets/sec
>>>
>> I am also seeing the following in the logs....
>>
>> %PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could
>> not be programmed into TCAM and are being covered by a less specific
>> prefix
>>
> I hit that warning as well, IOS is 12.2(53)SE,
> and the routing table is not huge. If you ever
> find a clue, let me know...
>
> ME3400#sh ip route summary
> IP routing table name is Default-IP-Routing-Table(0)
> IP routing table maximum-paths is 32
> Route Source Networks Subnets Overhead Memory (bytes)
> connected 1 3 256 608
> static 0 2 192 304
> internal 3 3516
> Total 4 5 448 4428
> ME3400#
>
> ME3400#sh ip cef summary
> IPv4 CEF is enabled for distributed and running
> VRF Default:
> 30 prefixes (30/0 fwd/non-fwd)
> Table id 0
> Database epoch: 2 (30 entries at this epoch)
>
> ME3400#
>
> Cheers,
> Everton
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>
--
Tassos
More information about the cisco-nsp
mailing list