[c-nsp] Using EoMPLS where you'd normally use a VLAN

Arie Vayner (avayner) avayner at cisco.com
Tue Apr 27 13:53:17 EDT 2010


Yes, SIPs would allow you to do this.
Arie

-----Original Message-----
From: Jason Lixfeld [mailto:jason at lixfeld.ca] 
Sent: Tuesday, April 27, 2010 19:58
To: Arie Vayner (avayner)
Cc: <cisco-nsp at puck.nether.net>
Subject: Re: [c-nsp] Using EoMPLS where you'd normally use a VLAN

What about a 6500+Sup720+SIP?

On 2010-04-27, at 2:00 AM, "Arie Vayner (avayner)" <avayner at cisco.com>
wrote:

> Jason,
> 
> You can do this with some of the devices. For example 7600 with ES+
(or
> ES20/SIP) modules can terminate a pseudowire (either point to point or
> VPLS...) on a SVI and also have layer 3 configuration on it. The same
> applies to ASR9000...
> 
> This can be used for many interesting solutions such as HSRP across an
> MPLS domain, Layer 3 services for a VPLS domain etc.
> 
> The extra hardware is required as this requires extra processing...
> 
> Arie
> 
> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net
> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Jason Lixfeld
> Sent: Tuesday, April 27, 2010 01:50
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] Using EoMPLS where you'd normally use a VLAN
> 
> I'm wondering if I can use EoMPLS in a situation where I'd normally
use
> a VLAN.
> 
> For example, in a VLAN centric network, I'd have a node connected to
an
> access port on switch 1.  Switch 1 would be connected directly to
switch
> 2 over an appropriately configured 802.1q trunk port or access port.
> I'd assign an IP to an SVI on switch 2 and as long as the SVI had the
> same VLAN identifier as the access port on switch 1, I could pass
> traffic between the SVI on switch 2 and the node connected to the
access
> port on switch 1.
> 
> Is there an equivalent to this in EoMPLS land where I could do the
same
> thing using two devices that were both acting as P+PE devices?  I know
> that normally you can't assign an IP address on an interface that is
> also configured with an xconnect, but I'm wondering if there's a
feature
> out there somewhere that could make this sort of thing possible.
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/



More information about the cisco-nsp mailing list