[c-nsp] L2TPv3 question

[Ziv Leyes]

We tried to make a pseudowire yesterday with the following setup:

Side A has a certain device connected to C3750 Switch on port 19.
Port 20 on C3750 Switch is set as trunk and it's connected to C7200VXR router port g0/1
The xconnect is done on subinterface G0/1.200 (VLAN200 dot1q encapsulation
The other of the xconnect is a C2811 router on port f0/0 while its f0/1 port is connected to the device that needs to communicate with the device on the other end of the tunnel.

It didn't work and my colleague suspects it's because one side is tagged as vlan while the other is not.
Is there a way to make it work given the above mentioned setup?

Thanks,
Ziv


The information contained in this e-mail message and its attachments is confidential information intended only for the use of the individual or entity named above. If the reader of this message is not the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the sender, and then delete the message from your computer.  Thank you!

******** This mail was sent via Mail-SeCure System.********



 
 
************************************************************************************
This footnote confirms that this email message has been scanned by
PineApp Mail-SeCure for the presence of malicious code, vandals & computer viruses.
************************************************************************************