[c-nsp] rate-limit command not accepting ?

Leslie Meade lmeade at signal.ca
Wed Feb 10 20:10:35 EST 2010

While I would of agreed with you comment, why is it that I am able to put the rate limit commands on failover 6509 ?

-----Original Message-----
From: Asbjorn Hojmark - Lists [mailto:lists at hojmark.org] 
Sent: Wednesday, February 10, 2010 3:08 PM
To: Leslie Meade
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] rate-limit command not accepting ?

On Wed, 10 Feb 2010 11:00:55 -0800, you wrote:

> DTCCAT-CORE01(config-if)# rate-limit input 2096000 128000 128000 conform-action transmit exceed-action drop
>                                                           ^
> % Invalid input detected at '^' marker.

The rate-limit command is not supported on Catalyst 6500.
Use a policy-map with policing instead.


More information about the cisco-nsp mailing list