[c-nsp] 7600 + egress netflow + 12.2(33)SRE

[Atif Sid]

This is HW we have:

Mod Ports Card Type                              Model
--- ----- -------------------------------------- ------------------
  1    8  8 port 1000mb GBIC Enhanced QoS        WS-X6408A-GBIC
  2   48  48-port 10/100/1000 RJ45 EtherModule   WS-X6148A-GE-TX
  3   48  48-port 10/100/1000 RJ45 EtherModule   WS-X6148A-GE-TX

  5    9  Supervisor Engine 32 8GE (Hot)         WS-SUP32-GE-3B
  6    9  Supervisor Engine 32 8GE (Active)      WS-SUP32-GE-3B




On Tue, Jan 26, 2010 at 4:10 AM, Phil Mayers <p.mayers at imperial.ac.uk>wrote:

> On 01/25/2010 08:59 PM, Atif Sid wrote:
>
>> New code 12.2(33)SRE have removed the command ip flow egress from the
>> interfaces.  it shows the command but does not configure it?
>> example:
>>
>
> 7600s with PFC-based linecards don't support egress netflow, because the
> hardware does not - only ingress. Is this the kind of interface you're
> trying to configure on?
>
> I suspect the egress command was present previously either as a cosmetic
> bug (e.g. it was intended for WAN/ES cards but "accidentally" appeared for
> all interfaces) or was only capturing software-switches flows.
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>