[c-nsp] PBR

[Gary Smith]

Hi - I'm struggling to get PBR working on a 2811, wonder if someone can 
show me with where I'm being special.

The 2811 has two connections coming in on ATM0/2/0 (binding to Di1) and 
ATM0/3/0 (binding to Di0). I've got a small gaggle of VLANs. I'm trying 
to get VLAN10 sending/receiving everything over Di1 and everything else 
over Di0.

If I do ip route 0.0.0.0 0.0.0.0 Dialer0, everything goes over Di0, as 
expected. If I cancel that and change it to ip route 0.0.0.0 0.0.0.0 
Dialer1, then everything goes via that. So, I know that my connections 
are good. It's something internal I'm not getting right.

So, to start setting this up - everything is currently running over 
Dialer0. ATM0/2/0 is up over Di1, but there's no route for it.

VLAN10 is 192.168.10.0/24, so creating an access list as per this:

ip access-list extended Network10
permit tcp any 192.168.10.0 0.0.0.255
permit tcp 192.168.10.0 0.0.0.255 any

Then...

route-map PBR_Network10 permit 10
match ip address Network10
set interface Dialer1

interface Fa0/0.10
    description Network10Uplink
    ip policy route-map PBR_Network10

ip route 0.0.0.0 0.0.0.0 Dialer1 10

As I understand it, this should work - however, from the outside, trying 
to ping the address of Di1 results in no replies. Also, VLAN10 can't 
route over the connection, instead still routing over Di0.

What am I doing wrong?

Thanks!

Gary