[c-nsp] 7204VXR rebooted by watchdog hard reset with PA-FE in slot 1

Youssef Bengelloun-Zahr youssef at 720.fr
Mon Mar 8 11:33:48 EST 2010 

Hello,

It's a possibility I have considered as it is a refurb chassis.

Any other ideas ?

Thanks.

Y.



2010/3/8 Manu Chao <linux.yahoo at gmail.com>

> hardware issue: connector?
> On Mon, Mar 8, 2010 at 4:42 PM, Youssef Bengelloun-Zahr <youssef at 720.fr>wrote:
>
>> Hello community,
>>
>> I received a 7204VXR chassis with a I/O controler (no FE ports on it) et
>> plugged in it an old NPE-400 plus 2 PA-FE.
>>
>> PA-FE 1 in in slot 1.
>>
>> PA-FE 2 is in slot 2.
>>
>> Upgraded my bootloader with c7200-boot-mz.120-22.S.bin and my version of
>> IOS
>> is c7200-adventerprisek9-mz.122-33.SRD.bin.
>>
>> Here is my problem :
>>
>> When PA-FE1 is in slot1, the router loops during boot and the following
>> appears :
>>
>> *Mar  8 05:20:09.459: %SYS-5-RELOAD: Reload requested by console. Reload
>> Reason: Reload command.
>> System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1)
>> TAC Support: http://www.cisco.com/tac
>> Copyright (c) 2002 by cisco Systems, Inc.
>> C7200 platform with 524288 Kbytes of main memory
>>
>>
>> Self decompressing the image :
>>
>> ###########################################################################################################################################################################################################]
>>
>> %SYS-4-CONFIG_NEWER: Configuration from version 12.2 may not be correctly
>> understood
>> %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
>> %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
>> %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
>> %SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
>> Self decompressing the image :
>>
>> ###########################################################################################################################################################################################################]
>>
>> System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1)
>> TAC Support: http://www.cisco.com/tac
>> Copyright (c) 2002 by cisco Systems, Inc.
>>
>> *ROM: Rebooted by watchdog hard reset
>> *C7200 platform with 524288 Kbytes of main memory
>>
>>
>> When I remove the PA-FE from slot 1 or insert it in another slot (2,3 or
>> 4),
>> everything works like a charm. Moreover, swapping with another PA-FE in
>> slot1 causes the same problem !?!
>>
>> Here is a sh controller of the PA-FE in question (but inserted in slot 3)
>> :
>>
>> Interface FastEthernet3/0
>> Hardware is DEC21140
>>  dec21140_ds=0x65948454, registers=0x3D800000, ib=0xE179D40
>>  rx ring entries=128, tx ring entries=256, af setup failed=0
>>  rxring=0x7E179E40, rxr shadow=0x65948A38, rx_head=0, rx_tail=0
>>  txring=0x7E17A680, txr shadow=0x65948C6C, tx_head=2, tx_tail=2,
>> tx_count=0
>>  PHY link up
>>  CSR0=0xFFFA9082, CSR3=0xE179E40, CSR4=0xE17A680, CSR5=0xFC000000
>>  CSR6=0xE0000000, CSR7=0xFFFE0000, CSR8=0xFFFE0000, CSR9=0xFFFDD7FF
>>  CSR11=0xFFFE0000, CSR12=0xFFFFFF09, CSR15=0xFFFFFEC8
>>  TX state: stopped
>>  RX state: stopped - RESET or STOP RECEIVE command
>>  Far End Fault Indication (For FX Interface): OFF
>>  DEC21140 PCI registers:
>>  bus_no=6, device_no=0
>>  CFID=0x00091011, CFCS=0x02800006, CFRV=0x02000012, CFLT=0x0000FF00
>>  CBIO=0xDFEFFF81, CBMA=0x49000000, CFIT=0x000001D1, CFDA=0x0000EF00
>>  MII registers:
>>  Register 0x00:   0400  784B  2000  5C01  0081  0000  0000  0000
>>  Register 0x08:   0000  0000  0000  0000  0000  0000  0000  0000
>>  Register 0x10:   0000  0000  0000  0000        0000  0001  8060
>>  Register 0x18:   8020  0800  0000  3800  A3B9
>>  Software MAC address filter(hash:length/addr/mask/hits):
>>  need_af_check = 0
>>  0x00:  0  ffff.ffff.ffff  0000.0000.0000         0
>>  0x10:  0  0009.443e.8854  0000.0000.0000         0
>>  throttled=0, enabled=0, disabled=0
>>  rx_fifo_overflow=0, rx_no_enp=0, rx_state=0
>>  tx_underrun_err=0, tx_jabber_timeout=0, tx_carrier_loss=1
>>  tx_no_carrier=0, tx_late_collision=0, tx_excess_coll=0
>>  tx_collision_cnt=0, tx_deferred=0, fatal_tx_err=0, tbl_overflow=0
>>  rx_pak_len_err = 0, filtered_pak_cnt = 0
>>  tx_limited=0(256)
>>  HW addr filter: 0xE18E700, ISL Disabled
>>  Entry= 0:  Addr=FFFF.FFFF.FFFF
>>  Entry= 1:  Addr=FFFF.FFFF.FFFF
>>  Entry= 2:  Addr=FFFF.FFFF.FFFF
>>  Entry= 3:  Addr=FFFF.FFFF.FFFF
>>  Entry= 4:  Addr=FFFF.FFFF.FFFF
>>  Entry= 5:  Addr=FFFF.FFFF.FFFF
>>  Entry= 6:  Addr=FFFF.FFFF.FFFF
>>  Entry= 7:  Addr=FFFF.FFFF.FFFF
>>  Entry= 8:  Addr=FFFF.FFFF.FFFF
>>  Entry= 9:  Addr=FFFF.FFFF.FFFF
>>  Entry=10:  Addr=FFFF.FFFF.FFFF
>>  Entry=11:  Addr=FFFF.FFFF.FFFF
>>  Entry=12:  Addr=FFFF.FFFF.FFFF
>>  Entry=13:  Addr=FFFF.FFFF.FFFF
>>  Entry=14:  Addr=FFFF.FFFF.FFFF
>>  Entry=15:  Addr=0009.443E.8854
>>
>> I have been googling around but nothing very concluant so far.
>>
>> Any clues ?
>>
>> Thanks.
>>
>> Best regards.
>>
>> Cheers,
>>
>> --
>> Youssef BENGELLOUN-ZAHR ………………………………………………
>> Ingénieur Réseaux et Télécoms
>>
>>
>> Technopole de l'Aube  en Champagne - BP 601 - 10901 TROYES  Cedex 9
>> Agence Paris : 6, rue Charles Floquet - 92120 MONTROUGE
>> Tel                 +33 (0) 825 000 720
>> Tel. direct      +33 (0) 1 77 35 59 14
>> Tel. portable  +33 (0) 6 22 42 63 80
>> Email            ybz at 720.fr
>> ……………………………………………………………………………….....www.720.fr
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>
>


-- 
Youssef BENGELLOUN-ZAHR ………………………………………………
Ingénieur Réseaux et Télécoms


Technopole de l'Aube  en Champagne - BP 601 - 10901 TROYES  Cedex 9
Agence Paris : 6, rue Charles Floquet - 92120 MONTROUGE
Tel                 +33 (0) 825 000 720
Tel. direct      +33 (0) 1 77 35 59 14
Tel. portable  +33 (0) 6 22 42 63 80
Email            ybz at 720.fr
……………………………………………………………………………….....www.720.fr

More information about the cisco-nsp mailing list