[c-nsp] 7204VXR rebooted by watchdog hard reset with PA-FE in slot 1

Mon Mar 8 12:03:47 EST 2010

Hello Philip,

By default, the router boots with all its PA-FEs in shut down state.

I have tried to reboot several time (in shut down state), always the same.

Y.

2010/3/8 Philip Davis <pdavis at i2k.com>

> What happens if you boot with F1/0 configured for a shutdown state?
>
> On 3/8/2010 10:42 AM, Youssef Bengelloun-Zahr wrote:
> > Hello community,
> >
> > I received a 7204VXR chassis with a I/O controler (no FE ports on it) et
> > plugged in it an old NPE-400 plus 2 PA-FE.
> >
> > PA-FE 1 in in slot 1.
> >
> > PA-FE 2 is in slot 2.
> >
> > Upgraded my bootloader with c7200-boot-mz.120-22.S.bin and my version of
> IOS
> > is c7200-adventerprisek9-mz.122-33.SRD.bin.
> >
> > Here is my problem :
> >
> > When PA-FE1 is in slot1, the router loops during boot and the following
> > appears :
> >
> > *Mar  8 05:20:09.459: %SYS-5-RELOAD: Reload requested by console. Reload
> > Reason: Reload command.
> > System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1)
> > TAC Support: http://www.cisco.com/tac
> > Copyright (c) 2002 by cisco Systems, Inc.
> > C7200 platform with 524288 Kbytes of main memory
> >
> >
> > Self decompressing the image :
> >
> ###########################################################################################################################################################################################################]
> >
> > %SYS-4-CONFIG_NEWER: Configuration from version 12.2 may not be correctly
> > understood
> > %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
> > %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
> > %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
> > %SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
> > Self decompressing the image :
> >
> ###########################################################################################################################################################################################################]
> >
> > System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1)
> > TAC Support: http://www.cisco.com/tac
> > Copyright (c) 2002 by cisco Systems, Inc.
> >
> > *ROM: Rebooted by watchdog hard reset
> > *C7200 platform with 524288 Kbytes of main memory
> >
> >
> > When I remove the PA-FE from slot 1 or insert it in another slot (2,3 or
> 4),
> > everything works like a charm. Moreover, swapping with another PA-FE in
> > slot1 causes the same problem !?!
> >
> > Here is a sh controller of the PA-FE in question (but inserted in slot 3)
> :
> >
> > Interface FastEthernet3/0
> > Hardware is DEC21140
> >  dec21140_ds=0x65948454, registers=0x3D800000, ib=0xE179D40
> >  rx ring entries=128, tx ring entries=256, af setup failed=0
> >  rxring=0x7E179E40, rxr shadow=0x65948A38, rx_head=0, rx_tail=0
> >  txring=0x7E17A680, txr shadow=0x65948C6C, tx_head=2, tx_tail=2,
> tx_count=0
> >  PHY link up
> >  CSR0=0xFFFA9082, CSR3=0xE179E40, CSR4=0xE17A680, CSR5=0xFC000000
> >  CSR6=0xE0000000, CSR7=0xFFFE0000, CSR8=0xFFFE0000, CSR9=0xFFFDD7FF
> >  CSR11=0xFFFE0000, CSR12=0xFFFFFF09, CSR15=0xFFFFFEC8
> >  TX state: stopped
> >  RX state: stopped - RESET or STOP RECEIVE command
> >  Far End Fault Indication (For FX Interface): OFF
> >  DEC21140 PCI registers:
> >   bus_no=6, device_no=0
> >   CFID=0x00091011, CFCS=0x02800006, CFRV=0x02000012, CFLT=0x0000FF00
> >   CBIO=0xDFEFFF81, CBMA=0x49000000, CFIT=0x000001D1, CFDA=0x0000EF00
> >  MII registers:
> >   Register 0x00:   0400  784B  2000  5C01  0081  0000  0000  0000
> >   Register 0x08:   0000  0000  0000  0000  0000  0000  0000  0000
> >   Register 0x10:   0000  0000  0000  0000        0000  0001  8060
> >   Register 0x18:   8020  0800  0000  3800  A3B9
> >  Software MAC address filter(hash:length/addr/mask/hits):
> >  need_af_check = 0
> >   0x00:  0  ffff.ffff.ffff  0000.0000.0000         0
> >   0x10:  0  0009.443e.8854  0000.0000.0000         0
> >  throttled=0, enabled=0, disabled=0
> >  rx_fifo_overflow=0, rx_no_enp=0, rx_state=0
> >  tx_underrun_err=0, tx_jabber_timeout=0, tx_carrier_loss=1
> >  tx_no_carrier=0, tx_late_collision=0, tx_excess_coll=0
> >  tx_collision_cnt=0, tx_deferred=0, fatal_tx_err=0, tbl_overflow=0
> >  rx_pak_len_err = 0, filtered_pak_cnt = 0
> >  tx_limited=0(256)
> >  HW addr filter: 0xE18E700, ISL Disabled
> >   Entry= 0:  Addr=FFFF.FFFF.FFFF
> >   Entry= 1:  Addr=FFFF.FFFF.FFFF
> >   Entry= 2:  Addr=FFFF.FFFF.FFFF
> >   Entry= 3:  Addr=FFFF.FFFF.FFFF
> >   Entry= 4:  Addr=FFFF.FFFF.FFFF
> >   Entry= 5:  Addr=FFFF.FFFF.FFFF
> >   Entry= 6:  Addr=FFFF.FFFF.FFFF
> >   Entry= 7:  Addr=FFFF.FFFF.FFFF
> >   Entry= 8:  Addr=FFFF.FFFF.FFFF
> >   Entry= 9:  Addr=FFFF.FFFF.FFFF
> >   Entry=10:  Addr=FFFF.FFFF.FFFF
> >   Entry=11:  Addr=FFFF.FFFF.FFFF
> >   Entry=12:  Addr=FFFF.FFFF.FFFF
> >   Entry=13:  Addr=FFFF.FFFF.FFFF
> >   Entry=14:  Addr=FFFF.FFFF.FFFF
> >   Entry=15:  Addr=0009.443E.8854
> >
> > I have been googling around but nothing very concluant so far.
> >
> > Any clues ?
> >
> > Thanks.
> >
> > Best regards.
> >
> > Cheers,
> >
>
>
> --
>
> Philip Davis
> Systems Administrator
> I-2000 Inc.
> (616) 532-8425
> 888-234-4254
>

-- 
Youssef BENGELLOUN-ZAHR ………………………………………………
Ingénieur Réseaux et Télécoms

Technopole de l'Aube  en Champagne - BP 601 - 10901 TROYES  Cedex 9
Agence Paris : 6, rue Charles Floquet - 92120 MONTROUGE
Tel                 +33 (0) 825 000 720
Tel. direct      +33 (0) 1 77 35 59 14
Tel. portable  +33 (0) 6 22 42 63 80
Email            ybz at 720.fr
……………………………………………………………………………….....www.720.fr