[c-nsp] SCE 8000 with 2*SCM-E

[Mikhail Schedrin]

Sorry that I didn't answer so much time.
As I got to know from cisco engineers 2 SCMs are supported only by software
3.6 that hasn't released yet.
I did open TAC case, they don't know that 2 SCMs are not suported by 3.5.5.
They also do not have 2 SCMs in a lab to test it :(

On 3 March 2010 19:17, Ghattas Jacob <gatesman at gmail.com> wrote:

> Mikhail,
> Be sure both sce have the same pkg installed before you insert the second
> one to the sce.
> Which version are you running as it should be 3.6 and higher...
>
> Jacob
>
>
> On Wed, Mar 3, 2010 at 5:17 PM, Arie Vayner (avayner) <avayner at cisco.com>wrote:
>
>> Mikhail,
>>
>> I recommend you open a TAC case, as this could be a hardware problem,
>> but it requires some debugging...
>>
>> Arie
>>
>> -----Original Message-----
>> From: cisco-nsp-bounces at puck.nether.net
>> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Mikhail Schedrin
>> Sent: Wednesday, March 03, 2010 11:46
>> To: cisco-nsp at puck.nether.net
>> Subject: [c-nsp] SCE 8000 with 2*SCM-E
>>
>> Hi.
>> Does anybody have the experince of using SCE8000 with two SCM-E modules?
>> We
>> got the second SCM-E couple of days ago and SCE always boots in recovery
>> mode, when I install the second module.
>> I could not find any documentation about installing and configuring the
>> second SCM-E, I think it should work out of the box. Actually it does
>> not.
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>
>


-- 
С уважением,
Щедрин Михаил
Начальник отдела ТП2
SkyNet Telecom http://sknt.ru
Санкт-Петербург
тел. +7 812 600-75-35 ext. 554
моб. +7 911 934-79-83