[c-nsp] OSPF Adjacencies

[shake righa]

Sascha,

Output
show ip ospf
Routing Process "ospf 64512" with ID <loopback_ip>
 Supports only single TOS(TOS0) routes
 Supports opaque LSA
 Supports Link-local Signaling (LLS)
 Initial SPF schedule delay 5000 msecs
 Minimum hold time between two consecutive SPFs 10000 msecs
 Maximum wait time between two consecutive SPFs 10000 msecs
 Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs
 LSA group pacing timer 240 secs
 Interface flood pacing timer 33 msecs
 Retransmission pacing timer 66 msecs
 Number of external LSA 0. Checksum Sum 0x000000
 Number of opaque AS LSA 0. Checksum Sum 0x000000
 Number of DCbitless external and opaque AS LSA 0
 Number of DoNotAge external and opaque AS LSA 0
 Number of areas in this router is 1. 1 normal 0 stub 0 nssa
 External flood list length 0
    Area BACKBONE(0) (Inactive)
Number of interfaces in this area is 8 (1 loopback)
Area has message digest authentication
SPF algorithm last executed 02:48:12.820 ago
SPF algorithm executed 109 times
Area ranges are
Number of LSA 1. Checksum Sum 0x00515C
Number of opaque link LSA 0. Checksum Sum 0x000000
Number of DCbitless LSA 0
Number of indication LSA 0
Number of DoNotAge LSA 0
Flood list length 0

Have also tried clearing the ospf process but the adjacencies are not
forming.
show ip ospf databse is only showing the loopback ip.

Having ospf with md5 key running on point to point interfaces.
the point to point is indeed reachable.
Also having a loopback ip on the router beign part of area 0.

Any particular reason as to find ospf hello messeges no beign seen during
debug?


On Tue, May 11, 2010 at 10:43 PM, Sascha E. Pollok <nsp-list at pollok.net>wrote:

> Hello Shake,
>
>
>  Having a problem whereby ospf adjacencies are not forming.
>>
>> a debug on ospf ajacencies is also not showing any thing
>>
>> show ip protocols shows ospf as beign identified and as beign configured.
>>
>> have tested by removing any authentication keys but nothing.
>> Running on a cisco 2621 (MPC860) IOS image c2600-telco-mz.123-15b.bin
>>
>
> anything special like OSPF's network statement pointing to a
> network configured as secondary on an Ethernet interface or
> something else tricky? It could be helpful sharing a
> "sh ip ospf interface .." and/or configuration snippets.
>
> Thanks
> Sascha
>