[c-nsp] Named ACL can`t be applied in the 10GigEthernet port

[Stephen.Chen]

Hi guys,

     Platform:*GSR12416*
     Software:*IOS (tm) GS Software (C12KPRP-K4P-M), Version 12.0(32)SY6,
RELEASE SOFTWARE (fc2)*
     Show diag with the 10GigEthernet Card:
*
*
*PA-XY-CWC-GSR-001# sh diag 13*
*
*
*SLOT 13 (RP/LC 13): 1 Port 10GigEthernet Plus Single Mode/ER SC connector*
*  MAIN: type 106,  800-22852-05 rev A0*
*        Deviation:  D080209*
*        HW config: 0x02    SW key: 00-00-00*
*  PCA:  73-7182-06 rev A0 ver 2*
*        Design Release 2.0  S/N SAD094100EM*
*  MBUS: Embedded Agent*
*        Test hist: 0x00    RMA#: 00-00-00    RMA hist: 0x00*
*  DIAG: Test count: 0x00000000    Test results: 0x00000000*
*  FRU:  Linecard/Module: 1x10GE-ER-SC=*
*        Processor Memory: MEM-LC4E-256=*
*        Packet Memory: MEM-LC4E-PKT-512=*
*  L3 Engine: 4 - Enhanced Services OC192/QOC48 (10 Gbps)*
*  MBUS Agent Software version 2.68 (RAM) (ROM version is 2.42)*
*  ROM Monitor version 1.4*
*  Fabric Downloader version used n/a (ROM version is 8.1)*
*  Primary clock is CSC 1*
*  Board is analyzed *
*  Board State is Line Card Enabled (IOS  RUN )*
*  Insertion time: 1y9w (14w1d ago)*
*  Processor Memory size: 268435456 bytes*
*  TX Packet Memory size: 268435456 bytes*
*  RX Packet Memory size: 268435456 bytes*
*  0 crashes since restart*
*     *
*       * After I apply the named acl to it ,I can`t seen the command "ip
access-group anti_virus in" ,but in other GigEthernet/POS

Thanks,
*
*
*Stephen.Chen*
*
*
*
*