[c-nsp] MPLS qos on 6500/sup720 - setting EXP when it shouldn't?

[daigo nakayama]

> #sh mls qos detailed
>  QoS ip packet dscp rewrite disabled globally

If there is the following command in your config, the command might be a cause.

no mls qos rewrite ip dscp

---
nkymdg


2010/11/17 Phil Mayers <p.mayers at imperial.ac.uk>:
> On 17/11/10 12:50, Manu Chao wrote:
>>
>> Can you please send "show mls qos detailed"?
>
> #sh mls qos detailed
>  QoS is enabled globally
>  Policy marking depends on port_trust
>  QoS ip packet dscp rewrite disabled globally
>  Input mode for GRE Tunnel is Pipe mode
>  Input mode for MPLS is Pipe mode
>
>  QoS is vlan-based on the following interfaces:
>    Te1/1 Te1/5 Te2/1 Te2/2 Te2/3 Gi8/41 Gi9/39 Po1 Po2
>  Vlan or Portchannel(Multi-Earl) policies supported: Yes
>  Egress policies supported: Yes
>
>
> ...then a load of per-module stats noise - representative example:
>
>  ----- Module [1] -----
> Traffic:                          Total pkt's
> ---------------------------------------------
>
> Total packets:                         559899
> IP shortcut packets:                   557056
> Packets dropped by
> policing:                                   0
> IP packets with TOS
> changed by policing:                        0
> IP packets with COS
> changed by policing:                      769
> Non-IP packets with COS
> changed by policing:                   474422
> MPLS packets with EXP
> changed by policing:                        0
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>