[c-nsp] pixhelp

[Deric Kwok]

Hi

The verion is Cisco PIX Firewall Version 6.3(1)

I used the same ssh logon and pw info. It can use ssh but won't work https

The blank one user and pw won't work

How can I setup the https logon and pw?

Thank you so much


On Tue, Oct 26, 2010 at 6:35 PM, Michael K. Smith - Adhost
<mksmith at adhost.com> wrote:
> Hello:
>
> If you are being asked for a username and password that means the PIX
> has been configured previously with that information.  A config-less PIX
> will just show a ciscopix> prompt and have no username and password.
> Check out
> http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_
> recovery09186a008009478b.shtml for information on how to reset the
> password.
>
> Setting up http access is dependent upon the operating system, so it
> will be hard to assist you before knowing whether or not it's in the 6.x
> or 7.x train.
>
> Mike
>
> --
> Michael K. Smith - CISSP, GSEC, GISP
> Chief Technical Officer - Adhost Internet LLC mksmith at adhost.com
> w: +1 (206) 404-9500 f: +1 (206) 404-9050
> PGP: B49A DDF5 8611 27F3  08B9 84BB E61E 38C0 (Key ID: 0x9A96777D)
>
>
>> -----Original Message-----
>> From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-
>> bounces at puck.nether.net] On Behalf Of Deric Kwok
>> Sent: Tuesday, October 26, 2010 2:07 PM
>> To: Cisco Network Service Providers
>> Subject: [c-nsp] pixhelp
>>
>> Hi
>>
>> Do I need to setup the pix brower login and pw to access?
>>
>> If not, what is the default pw? I try cisco and cisco. it won't work
>>
>> If yes, How can I setup the pw in command line
>>
>> Thank you so much
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>