[c-nsp] VLAN-based EoMPLS

[Lee Riemer]

Can you see the far end in your arp table?

On 10/28/2010 1:46 AM, Manaf Al Oqlah wrote:
>
> Hi,
>
> I have established an EoMPLS circuit on ME3750 switches as below. everything seems to be working fine as my virtual circuit is UP
> but my problem is that I cant ping IP address CE02 from CE01
>
> PC01---CE01---PE01---PE02---CE02---PC02
>
> I have applied the following configuration on PE01&  PE02 ES ports
>
> interface loopback 0
> ip address 1.1.1.1 255.255.255.255
> !
> interface GigabitEthernet1/1/1
> description to PE02
>   ip address 10.0.0.1 255.255.255.252
>   mpls ip
> !
> interface GigabitEthernet1/1/2
> description to CE01
> switchport mode access
> switchport access vlan 100
> !
> vlan 100
> !
> interface vlan 100
> xconnect 2.2.2.2 100 encapsulation mpls
>
> where could me my problem!
>
> Regards,
> Manaf Al Oqlah
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

-- 
Lee Riemer
Director of Technical Operations
Bestline Communications, L.P.
Voice: 1+512.328.9095
Fax: 1+512.328.0038